Back from the dead to this thread. Since my last update I have moved, COVID, etc but all that stuff is boring. Back to the car where I put a full new wiring harness in, installed a new stereo with 2 amps and a sub, and a cool head unit that runs off android. Finished the engine mounts and reinstalled the engine/4l60 trans. Installing the engine is wayyy harder without a big gantry that can lift it up and in. The poor little engine hoist was at its max height, I had to lower the car almost to the ground, and it still barrrely made it over the front of the car. With the new trans installed I made the new trans tunnel cover. Next steps is to do the new trans crossmember, mount the brake master cylinder under the floor, and figure out exhaust. Good to be back!